Description
LED Lamp FUTURO TOUCH 22w/48
Technical specifications
- Power: 22 W
- Voltage: 24 V DC
- LED quantity: 21 szt.
- Dimension: 210x160x45mm
- Vave lenght: 365-405 nm
- Timer 30s, 60s , 99s (low heat mode)
Low Heat Mode - This system is responsible for the progressive heating of the lamp. The power increase will happen first after 30s and then after 50s. The mode reduces the feeling of burning on the plate, especially when curing gel stylizations.
Application
1. Connect the AC adapter to the power supply terminal of the lamp.
2. Open the Lamp Cover.
3. After turning on the unit, select the lamp operation time by using the timer:
- once using the button - 30s
- Press the button twice for 60 seconds.
- Press the button three times for 99 seconds. - LOW HEAT MODE
When the Timer mode is selected, the remaining time until the end of illumination is displayed.
4. If a hand is removed from under the lamp during the selected timer time, the timer stops and the remaining curing time is shown on the display. To resume lamp operation for the remaining time, slide your hand under the lamp again. Press the Timer button again to select the next Timer time (e.g. from 30s to 60s). 5.
5. If you do not use the Timer buttons, the infrared sensor will start when you put your hand into the lamp. The maximum lamp operation time without starting the Timer is 99 seconds.
If you start the lamp using the motion sensor, the active time counter will be displayed.
*Read the manual before use - it contains all the information and technical parameters for the milling machine.
